Even though Bosch dishwashers do have a reputation for being reliable, there are also situations where you might see an error code from time to time. If you see a Bosch dishwasher error code E14, what does this mean? What can you do to fix this issue? Take a look at a few important points below.
What Does a Bosch Dishwasher Error Code E14 Mean?
The vast majority of Bosch dishwashers have a water heater. It is easier for you to clean your dishes if you use hot water because this is better for removing gunk from your dishes. First, the dishwasher fills up with cold water. Then, the water runs through a small circle until the water gets the right temperature.
Then, the water heater is responsible for ejecting hot water all over your dishes, getting them clean. Each Bosch dishwasher is equipped with something called a water flow sensor. If there is something wrong with the water flow sensor, the self-diagnosis system in your dishwasher is going to display this error code.
What are some of the reasons why you might be spotting this error code?
P.S. In case you are experiencing different errors on your Bosch dishwasher, feel free to check our other guides below:
- Guidelines for fixing Bosch dishwasher error code E19
- Guidelines for fixing Bosch dishwasher error code E25
- Guidelines for fixing Bosch dishwasher error code E17
What Causes an Error Code E14 Issue?
Similar to other parts in your dishwasher, there are a number of reasons why your dishwasher might be displaying this error. If you are seeing this code, there is something wrong with the water flow sensor.
It is important to take a look at the center as well as the wiring. For example, there may be a connection problem, meaning the water flow sensor is not receiving a signal from the control module.
A few of the most common reasons why you might be seeing this error code include:
- There might not be enough pressure in the system. If that is the case, the water flow sensor is not going to have any water flowing through it. Therefore, the error code is going to appear.
- The pressure flowing through the water flow sensor might be too high. If that is the case, the water flow sensor might be breaking, leading to this error code.
- There could also be a problem with the intake valve. If the intake valve is not working properly, the water flow sensor is not going to work properly.
- There could also be a problem with the electronic board. If the electronic board has been burnt, you are going to see an error code.
Regardless of the reason why you might be seeing this error code, it is time to solve the issue.
How Do You Fix This Error Code?
If you are trying to fix an error code E14, the first thing you need to do is disconnect the system. Then, wait between 10 and 15 minutes. After this, you should plug the dishwasher and once again. See if the error code is gone. If the error code is gone, it was probably an issue with a connection.
If you are still seeing the error code, it is time to check the flow of the sensor itself. The first thing you need to do is disconnect the hose from the case. Then, once the hose and the filter mesh were under running water to see if anything was clogged. If the dishwasher starts running again, you have fixed the issue.
Finally, if you are still seeing the error code, it is time to check the fill valve. If the fill valve is clogged, you need to disconnect it. There is a screw holding it in place. Remove the screw, remove the fill valve, and then replace it with a new valve.
If you have done all of these steps and there is still something wrong with the dishwasher, it is time to reach out to a professional who can help you. That way, you can figure out if you need to fix a part, replace a part, or replace the entire dishwasher.