You rely on your dishwasher to work properly. Therefore, it can be frustrating if you take a look at your Bosch dishwasher only to see an error code E13. What does this mean? What do you need to do to address this issue? Take a look at some helpful information below.
What Causes a Bosch Dishwasher Error Code E13?
If you are noticing this error code, this is a sign that the temperature of the water is too hot. It is important for you to use hot water to wash your dishes. It is easier for you to get the gunk off of your plates and cups.
At the same time, there is also a situation where the water temperature could be too hot. If that is the case, your dishwasher is going to have a difficult time processing it. If the water is too hot, it could also damage some of the interior parts of your dishwasher.
In general, the water temperature should not be higher than 75 degrees C. If the water temperature exceeds this barrier, then the error code could appear. There is also a chance that your dishwasher will stop working.
Exclude a Sensor Error
If you are trying to figure out what is wrong with the dishwasher, the first thing you need to do is exclude a sensor error. Therefore, you could start by resetting the entire dishwasher.
To do this, the first thing you do is unplug your dishwasher. Then, wait between 10 and 15 minutes. This will give your dishwasher plenty of time to reset. Then, plug the dishwasher in once again.
If the area code is gone, this is a sign that you have resolved the issue. Your dishwasher should be working normally again. On the other hand, if you are still getting this error code, it is time to take a closer look at how to fix it.
P.S. In case you are experiencing different errors on your Bosch dishwasher, feel free to check our other guides below:
- How to Fix Bosch Dishwasher Error Code E14
- Guidelines for fixing Bosch dishwasher error code E19
- Guidelines for fixing Bosch dishwasher error code E25
- Guidelines for fixing Bosch dishwasher error code E17
How To Fix an E13 Error Code on Your Bosch Dishwasher
If you are still seeing this error code, it is time to take a closer look at what might be causing it.
The next thing you need to do is take a look at the temperature sensor. You might also need to connect your dishwasher to the cold water tap.
When you are looking at the dishwasher, you need to look closely at his contacts. There is a chance that the detector contacts could be burnt out. Or, they could be oxidized. You should start by cleaning the contacts thoroughly. Then, you should grab a multimeter.
Use your multimeter to take a look at the life of the wires. If you find that some of the wires are dead, you may need to replace them. If you find that a lot of the wires are out, then you may need to replace the entire element. If that is the case, it may be better for you to reach out to a professional.
If you find that all of your parts are still in good working order, then you may need to connect your dishwasher to the cold water tap instead. Even though it is easier for you to get your dishes clean using hot water, the cold water could be safer for your dishwasher. Even though you could turn down the temperature on your water heater, this could make other tasks, such as showers, less comfortable. You need to decide whether you want to connect your machine to the cold water tap or turn down your hot water heater.
When you are going through this process, it is important to put safety first. If you are uncomfortable with any of these steps, you need to reach out to a professional who can help you. That way, you did not run the risk of hurting yourself during the repair process. You can also make sure the issue has been handled appropriately on the first attempt.